Press
Training Week
A useful outline for training week on South African print floors, written for crews who handle curing equipment as part of the daily run.
How Training Week runs on a busy floor
Training Week outlines a block of operator training around curing equipment on the print floor. It is relevant to crews using flash dryers, ceramic IR and quartz banks in the daily run.
Training Week starts with the press format, ink system, and the curing gear used on each shift. Gauteng dust, Durban moisture, and planned outages can change flash height, dwell time, and lamp choice during operator drills. Include the site, the line layout, and any fault the crew has seen on the flash dryer station.
Add a clear photo of the current setup before training begins. The pack for the week should include a one page settings note for the press side, with flash distance, belt speed where fitted, and shutdown checks. That record helps the next crew repeat the same curing routine without trial and error.
Training pack for press crews
The week should end with written settings, an operator check sheet, and a clear record of which unit was used on each job. One tested process for a ScreenMaster-style flash cell or an IR bank is worth more than a stack of loose notes that no one uses at handover.
Link the week plan to the current fault log and a fresh entry in the Cure log before adding extra machine time. Check one more sample print after any adjustment to height, heat, or timer values. If you send details through the contact form, name the press, dryer type, and the issue seen during production.
- Shift notes matched to your curing setup
- Photos taken before first training pass
- Operator points captured for each crew
Conditions that affect curing drills
Training plans often need to fit around OR Tambo freight timings, Sunnyrock dispatch windows, and older Crown Mines premises where power supply can be uneven. A ceramic IR lesson for a garment line is not the same as a quartz bank session on cartons or sleeves. State whether the team needs start up basics, fault finding, or repeatability checks across shifts.
Sea air near Durban can shorten cleaning intervals on reflectors and guards. Inland sites around Johannesburg usually need more wiping of dust around sensors, lamp housings, and control panels. When outages are likely, include the restart sequence and the first print test after power returns.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
What to send before the week
Outline the training need with site photos, shift timing, machine type, and any operating problems already seen on the flash dryer line. Keep the subject line clear.
Send site photos, shift times, machine type, and a short note on mis-cures, scorching, or uneven gel seen on recent runs. That gives the training plan enough detail to cover flash dryers, ceramic IR, or quartz banks with the right checks for the line.